SUPPORT - ICP DAS

Industrial Communication

Search for Subjects

SUBJECT

VIEWS

FAQ TYPE

MODEL

LAST UPDATED

DETAIL

I-2534 / I-5534-M FAQ

43

Troubleshooting

2021-11-04

NO.	Subject
Q01	What is the maximum FPS of the I-2534?
Q02	How to implement the 6 ports CAN switch with the I-2534?
Q03	How to manage reduce the data flow in 12 ports CAN switch?
Q04	How much delay time does the I-2534 take?
Q05	How to divide one CAN network into two groups with I-2534 module?
Q06	How to configure CAN 1 as input and CAN 2, 3, 4 as output within I-2534 module?
Q07	If I only connect the I-2534’s CAN 1 & 2 and CAN 3 & 4 is open, it will work fine between CAN 1 & 2 ?
Q08	How to build robust and flow controlled CAN network?
Q09	Update Firmware fail?
Q10	What is the MTBF of the I-5534-M?
Q11	Does the I-5534-M could extend CAN bus length?

ECAN-240 FAQ

67

Troubleshooting

2020-04-21

NO.	Subject
Q01	In Modbus TCP server mode, the user read the wrong CAN data form CAN port 2.
Q02	When the user set specific CAN ID with CAN 2.0B, the value of CAN ID is incorrect in setting.
Q03	When the user read CAN message with different data length via Modbus TCP command, the Modbus TCP response has invalid CAN data in Modbus format.
Q04	After the user sets the Modbus TCP Client write Table, some CAN-ID values are incorrect.
Q05	How to find or restore the Module's IP when the user forgets it ?

I-2532 / I-2533 / I-2533CS FAQ

96

Troubleshooting

2021-11-04

NO.	Subject
Q01	What is the difference between I-2532s and I-2533s?
Q02	How to calculate the working distance and the device numbers on the same CAN network while using I-2532s?
Q03	May I mix I-2532s and I-2533s in the same CAN network?
Q04	If some bus error happens on one side of I-2532s, is there any affection to my system?
Q05	If some error happens on one side of I-2533s, is there any affection to my system?
Q06	The Rx and Tx LED are flashing on one side of the I-2532. And the Rx and Tx LED are off on the other side of the I-2532. What happen would make this condition?
Q07	What is the relationship of some error conditions and the Rx and Tx LED of the I-2532?
Q08	Why the I-2532 modules stop to convert the CAN single to fiber single after a long time test?
Q09	I can’t connect with I-2533 via utility v1.01 and it shows error message ”1.03 is not a valid floating point value” .
Q10	Does the I-2533CS series support different CAN bus protocol over its network?