New products
New Product: ZT-2055
Wireless 8-channel Isolated Digital Input and 8-channel Isolated Digital Output Module
The ZT-2055 offers 8 isolated channels for digital input and 8 isolated channels for digital output. Either sink-type or source-type digital input can be selected via wire connections. All digital input channels are also able to be used as 16-bit counters. The ZT-2055 supports sink-type output with short circuit protection. There are options to enable both power-on and safe values......more
New Product: PROFI-5018
PROFIBUS 10-ch Thermocouple input module
PROFIBUS is an open, digital communication system with a wide range of applications, particularly in the fields of factory and process automation. PROFIBUS is suitable for both fast, time-critical applications and complex communication tasks.
The PROFI-5018 is one of the PROFIBUS DP series products produced by ICP DAS......more
New product: CAN-2026C
6-ch Analog Input, 2-ch Analog Output, 2-ch Digital Input and 1-ch Digital Output CANopen Slave Module
CANopen is a kind of the CAN-based network protocols and mainly used for embedded network of machine control, such as industrial machine control, aircraft engine monitoring, factory automation, medical equipment control, remote data acquisition, environmental monitoring, packaging machine control and so forth. The CAN-2026C module follows the specifications CiA 301 version 4.02 and CiA 401 version 2.1, and can be communicated by the standard CANopen protocols......more
New Product: I-2533CS-A/B, A CAN to One-wire Single-mode Fiber Bridge
The I-2533CS-A/B is a type of CAN-to-Fiber Bridge that can be used to establish a connection between two CAN networks. It supports Wavelength Division Multiplexing (WDM) technology so that only a single fiber cable is needed for transmitting bi-directional CAN data. As the I-2533CS-A and I-2533CS-B must be paired because of hardware limitations, this means that the cost of deploying fiber cable can be effectively reduced......more
New Product: CA-IR-SH2251-360 (Semi-sphere-headed IR blaster cable)
General IR emitting cables are directional and with longer remote control distance because of the small IR emitting angle. However, the remote control is only effective on the condition of aiming the emitting header at the appliances or putting the header near the IR receiver. If there are many IR appliances in a room, it will need many IR emitting cables which increase the cable cost and the time of installation......more
New release
End of Life Notification for PISO-730
ICP DAS hereby formally gives End Of Life (EOL) notification that the PISO-730 will be phased out of production. The suggested replacement device is PISO-730U......more |
Applications
Energy Storage System
This system can improve the usage efficiency of the electrical power. During the off-peak time of the electricity use, the unused electricity can be stored in the battery. When the peak time is coming, these batteries supply the power to the electric grid. The customer utilizes one of the I-8120Ws in VP-25W1 to monitor the battery status, and another is used to feedback these data to the XP-8341. The XP-8341 transmits the status to the PC via Ethernet and control the charge time by the breaker. (more...)
Petrochemical GAS Pressure Detection System
The conveying pipes are everywhere in the petrochemical plants, and used for conveying the variety liquids and gases which may be poison and flammable. The situations of these liquids and gas must be presented and handled in the control center. The customer uses the WP-8841 with the touch screen to be the HMI and control system. On the WP-8441, there is an I-8064W and an I-87H17W. The I-87H17W is a HART AI module, and is applied for received the 8 ABB pressure transmitters which monitors the gas pressure through the pipes. This control system not only displays the gas pressure on the touch screen directly, but triggers the alarm while the gas pressure exceed the upper limitation.(more...)
|