|
|
|
|
New product: I-87124(DeviceNet Master Module for Wincon-8000 and I-8000) is released now |
|
|
|
|
|
DeviceNet is a simple, open networking solution that reduces the cost and time to wire and install industrial automation devices, while providing interchangeability of like components from multiple vendors. ICP DAS’s I-87124 DeviceNet master products increase flexibility and efficiency in your control system. I-87124 can integrate the industry's DeviceNet slave devices into Wincon-8000 or I-8000 series controllers. ICP DAS also provide a wide variety of DeviceNet slave modules (CAN-8124, CAN-8224...etc) |
|
|
|
|
|
|
|
|
|
|
|
The I-87124 provides a variety of scan functions and debugging functions. These functions help you to scan the slave devices or check the slave devices easily and quickly when customizing your DeviceNet network or developing the application programs. ICP DAS I-87124 help you not only get started with DeviceNet quickly and easily but also stabilize and simplify customizing Devicenet applications. The general application architecture is depicted as the following figure. |
|
|
|
|
|
|
|
|
|
|
|
DeviceNet Master Features: |
|
|
|
|
|
- Programmable transfer-rate 125K, 250K, 500K.
- Every port support maximum nodes up to 64
- Support Group 2 Only Server functions
- Predefined Master-Slave Connection Set
- Programmable Master MAC ID.
- The maximum Fragment number is (Input/Output) up to 64
- I/O Operation Mode support: Poll, Bit-Strobe and Change Of State/Cyclic
- Auto-scan slave device function.
- UCMM supported
- On-line add device into and remove device from network.
- Boot-up auto communicate with slave devices.
|
|
|
|
|
|
You can visit the I-87124 website of ICP DAS as shown below.
http://www.icpdas.com/products/Remote_IO/can_bus/I-87124.htm |
|
|
|
|
|
|
 |
|
|
