Note:These Command Just for Slave
I-8000 Series(I-8410,I-8810)
Command
$AASiC
Description
This command for clear the Digital Low Latch and
High Latch
value from the specified slot of Digital I/O module.
This command only applies on all 87K digital I/O modules with digital
input channel which are plugged
in the specified Slot of the I-8000 system.
Syntax
$AASiC [CHK](cr)
#
a delimiter character
AA
address number of the I-8000 system. AA= 00 ~ FFh
Si
slot number of the module. i = 0 ~ 3 or 0 ~ 7
C
Command for Clear Latch
[CHK]
2 characters of Checksum
(cr)
Character Return(0x0D) for denote the end of the command
Response
Valid Command
!AA[CHK](cr)
Invalid Command
?AA[CHK](cr)
Syntax error or communication error may get no response.
!
delimiter for valid command
AA
address number of the I-8000 system. AA= 00 ~ FFh
?
delimiter for invalid command
[CHK]
2-characters of Checksum
(cr)
Character Return(0x0D) for denote the end of the response
Example
Command
$01S1C
Response
!01
Description
The example clear the digital module's low latch
and high latch value from slot 1 of the I-8000 system at address
01h.
Modules
I-87040, I-87051, I-87052, I-87053, I-87054,
I-87055, I-87057,
I-87063
Note: This command only support all 87K DIO modules which
are insert into to i-8000 MCU.