Command |
Description |
%AANNTTCCFF |
Set Module Configuration |
$AA0 |
Span calibration |
$AA1 |
Offset calibration |
$AA2 |
Read configuration |
$AA5VV |
Set channel enable/disable status |
$AA6 |
Read channel enable/disable status |
$AA7CiRrr
|
Set single channel range configuration |
$AA8Ci
|
Read single channel range configuration |
$AAF |
Read firmware version |
$AAM |
Read module name |
#AA |
Read analog inputs of all channels |
#AAN |
Read analog input of specified channel |
@AACS |
Clear maximum/minimum analog inputs |
@AACSN |
Clear maximum/minimum analog input of specified channel |
@AAOD
|
Read daughter-board connection status
|
@AARS |
Read maximum/minimum analog inputs |
@AARSN |
Read maximum/minimum analog input of specified channel |
~AA0 |
Read module status |
~AA1 |
Reset module status |
~AA2 |
Read host watchdog timeout setting |
~AA3ETT |
Set host watchdog timeout setting |
~AAI
|
Soft INIT |
~AAO(Name) |
Set module name |
~AARD
|
Read DCON response delay time |
~AARDVV
|
Set DCON response elay time |
~AATNN
|
Set soft INIT timeout |