STEP-200
 

Functional Description

 
 
 
    Ordering Information
    Optional Accessories
       
  PC Based I/O Boards
    Product List
       
       
 
 
 
  STEP-200
2-axis, High-speed Stepper Motor Controller
       
 

 
     
 
   
 
  Functional Description
 
     
STEPPER-200 is a plug-in, 2-axis, command-based stepper motor controller board for the IBM PC/XT/AT and compatibles. It also can be used in pulse-type servo motor control (pulse input type). This board has an μP build-in . ThisμP perform variety of motion control commands itself and share the loading of host computer . A 2Kbytes-FIFO is introduced as a command buffer. This buffer can provide 1360ms buffer time. Therefore the hardware architecture of STEP 200 is good for windows operation system. The STEP 200 will provide DOS, Windows 95 and Windows NT driver. It can offer real time motion control solution in windows system.
 
 
  Features & Specifications
 
     
 
  • 2-axis independent, simultaneous stepper motor control / servo motor control ( pulse input type )
  • DOS, windows 95, windows NT driver
  • Embedded Micro-processor
  • Command type interface
  • linear, circular interpolation
  • Acceleration / Deceleration : Automatic trapezoidal acceleration / deceleration
  • Output polarity can be programmable
  • 5 optical isolated digital inputs per axis for limit switches
  •  
       
     
      Software
     
         
     
  • Toolkit for DOS

  • Toolkit for Windows 95/98

  • Toolkit for Windows NT

  • Toolkit for Windows 2000/XP

  • Toolkit for LabVIEW 2000/XP

  • Toolkit for LabVIEW NT
  • Toolkit for LabVIEW 95/98

  • Driver for LINUX

  •  
       
      Specifications
     
  • Step rate : 1pps~250Kpps
  • Max. step count : +/- steps
  • Output pulse modes : CW/CCW or pulse / direction
  • 2500Vrms optical isolated signal output
  • 5 optical isolated digital inputs per axis for limit switches
  • Power Requirements: +5V mA typical , mA max
  • Operating temp range : 0 – 50 °C
  • Storage temp range : -200C to 70 °C
  • Power Requirements: +5V@ 500mA typical
  • Dimension : 108 mm x 167 mm
  •  
      Ordering Information
     

    STEP-200

    2-Axis Stepper Motor Control Board
    Include :CA-PC25M(25-pin Male D-sub Connector with Plastic Cover )
      Optional Accessories
     

    DN-25

    One 25-pin connector