Import Shared Library Report

2024年8月20日下午 05:38:31

Your generated files are installed in the following folder:
C:\Program Files (x86)\National Instruments\LabVIEW 2012\user.lib\I8120

Parsing header file warnings:
No errors/warnings occurred when parsing the header file.

The following errors/warnings occurred when generating the wrapper VIs for this shared library.

VI Not Executable
The VI is not executable because of one of the following reasons:
1. The shared library or a dependent file is not installed. To make the VI executable, you must install the shared library and all support files on the computer on which you run the VI.
2. A required custom control might be empty or cannot be found. To make the VI executable, update the custom control manually.
3. The VI contains a parameter with an unsupported data type. To make the VI executable, you must replace the empty cluster that the wizard generates with a control or indicator that uses supported data types.
    Add Cyclic Tx Msg.vi
    Adjust Date Time.vi
    Check186Mode.vi
    Check Cyclic Tx Rest Msg.vi
    Clear Buffer Status.vi
    Clear Data Overrun.vi
    Clear Receive Cmd.vi
    Clear Rx Soft Buffer.vi
    Clear Soft Buffer.vi
    Clear Tx Soft Buffer.vi
    Config.vi
    Config Without Struct.vi
    DPRAM Intt To I8120.vi
    DPRAM Memset.vi
    DPRAM Read Byte.vi
    DPRAM Read Dword.vi
    DPRAM Read Multi Byte.vi
    DPRAM Read Word.vi
    DPRAM Write Byte.vi
    DPRAM Write Dword.vi
    DPRAM Write Multi Byte.vi
    DPRAM Write Word.vi
    Delete Cyclic Tx Msg.vi
    Disable Cyclic Tx Msg.vi
    Disable SJA1000.vi
    Enable Cyclic Tx Msg.vi
    Enable SJA1000.vi
    End User Program.vi
    Get Dll Version.vi
    Hardware Reset.vi
    Init.vi
    Input Byte.vi
    Install User ISR.vi
    Is Tx Timeout.vi
    Output Byte.vi
    Read User Intt Type.vi
    Receive Cmd.vi
    Receive Without Struct.vi
    Remove Irq.vi
    Remove User ISR.vi
    Reset.vi
    Restore I8120.vi
    Run User Program.vi
    Rx Msg Count.vi
    SJA1000Config.vi
    Send Cmd.vi
    Send Receive Cmd.vi
    Send Without Struct.vi
    Set System Msg.vi
    Status.vi

Import Shared Library Report