
----------------------------------------------------------------------
CANopen demo: 

 Description: Simple I/O control with CANopen protocol

 Firmware : User_CP

 Host demo: I8k_demo for I-8000 host
            Wincon_demo for Wincon host
            Winpac_demo for Winpac host

----------------------------------------------------------------------
DeviceNet demo: 

 Description: Simple I/O control with DeviceNet protocol

 Firmware : User_DN

 Host demo: I8k_demo for I-8000 host
            Wincon_demo for Wincon host
            Winpac_demo for Winpac host

----------------------------------------------------------------------
Demo1: 

 Description: Use timer function to send a CAN message per X ms

 Baudrate setting: 1M bps

 How to use: When I-87120 receive a com port command that is _Ax (x is
             an unsigned long of decimal), then I-87120 will send a CAN
             message with x ms cycle.
             When I-87120 receive a com port command that is _B, the 
             cyclic CAN message will be stop.

 Firmware : F_demo1

 Host demo: 8k_demo1 for I-8000 host
            WinCon_demo1 for Wincon host
            WinPac_demo1 for Winpac host

----------------------------------------------------------------------
Demo2: 

 Description: Use interrupt function to send a CAN message

 Baudrate setting: 1M bps

 How to use: when I-87120 receive a CAN message that ID is 0x123 and the  
             bit1 of first byte of data is 1, then I-87120 will send a CAN 
             message that ID is 0x321 and 8 bytes data.

 Firmware : F_demo2

 Host demo: None

----------------------------------------------------------------------
Demo3: 

 Description: Convert CAN message to ASCII code

 Baudrate setting: 1M bps

 How to use: when I-87120 receive a CAN message that ID is 0x123, then
             I-87120 will convert the data of this CAN message to ASCII 
             code and send to com port.

 Firmware : F_demo3

 Host demo: 8k_demo3 for I-8000 host
            WinCon_demo3 for Wincon host
            WinPac_demo3 for Winpac host


----------------------------------------------------------------------
Demo4: 

 Description: Use ascii command to send a CAN message

 Baudrate setting: 1M bps

 How to use: when I-87120 receive a RS232 command 'A', a CAN message 
             will be send.

 Firmware : F_demo4

 Host demo: None


----------------------------------------------------------------------
Demo5: 

 Description: Use binary command to send a CAN message

 Baudrate setting: 1M bps

 How to use: when I-87120 receive a binary CAN message from com 1, a CAN message 
             will be send to CAN port.

 Firmware : F_demo5

 Host demo: 8k_demo5 for I-8000 host
            WinCon_demo5 for Wincon host
            WinPac_demo5 for Winpac host
