| Command |
Description |
| %AANNTTCCFF |
Set Module Configuration |
| $AA0 |
Span calibration |
| $AA1 |
Offset calibration |
| $AA2 |
Read configuration |
| $AA3 |
Read Cold-Junction Compensation(CJC) temperature |
| $AA5VV |
Set channel enable/disable status |
| $AA6 |
Read channel enable/disable status |
| $AA7CiRrr |
Set Single Channel Range Configuration |
| $AA8Ci |
Read Single Channel Range Configuration |
$AA9
|
Read Cold-Junction Compensation(CJC) temperature offset
|
| $AA9(Data) |
Set Cold-Junction Compensation(CJC) temperature offset |
$AA9Ci
|
Read Cold-Junction Compensation(CJC) offset of specificed channel
|
$AA9(Data)Ci
|
Set Cold-Junction Compensation(CJC) offset of specificed channel
|
| $AAF |
Read firmware version |
| $AAM |
Read module name |
$AAS1
|
Reload default calibrating parameter |
| #AA |
Read analog inputs of all channels |
| #AAN |
Read analog input of specificed channel |
| @AACS |
Clear maximum/minimum analog inputs |
| @AACSN |
Clear maximum/minimum analog input of specificed channel |
| @AARS |
Read maximum/minimum analog inputs |
| @AARSN |
Read maximum/minimum analog input of specificed channel |
| ~AA0 |
Read module status |
| ~AA1 |
Reset module status |
| ~AA2 |
Read host watchdog timeout setting |
| ~AA3ETT |
Set host watchdog timeout setting |
~AAC
|
Read Cold-Junction Compensation(CJC) sensor Enable/Disable
|
~AACN
|
Set Cold-Junction Compensation(CJC) sensor Enable/Disable
|
~AAEO
|
Read open wire detection status
|
~AAEON
|
Set open wire detection
|
~AAEV
|
Enable/Disable calibrate
|
~AAI
|
Soft INIT |
| ~AAO(Name) |
Set module name |
~AARD
|
Read DCON response delay time |
~AARDVV
|
Set DCON response elay time |
~AATNN
|
Set soft INIT timeout |