The PISO-DNM100 is a CAN bus communication board. It works with DeviceNet and has its own CPU on board. With the strength of DeviceNet, PISO-DNM100 is able to provide bus arbitration, error detection with auto correction and retransmission functions to your network. Besides, the 16-bit on-board CPU largely enhances the performance of users whole system, because it plays the role to preprocess and buffer data streams for further use; thus, it totally frees the burden of PC. ICP DAS releases 2 kinds of PISO-DNM100, one with D-sub 9-pin connector, and the other with 5-pin screw terminal connector.

The PROFI-8455, a slave device with 4 expansion slots, follows the PROFIBUS DP-V0 protocol. Under this architecture, the data can be transmitted up to 12Mbps. Users can totally experience the high-speed data transmission, and no longer be limited. The PROFI-8455 supports hot-swap for modules, and runs auto transmission rate detection; the above makes it user-friendly as well as time-saving for maintenance staffs. And it also passes 3000V DC power isolation protection and 4KV ESD protection for all terminals.

The I-7017Z is an analog input module. Its input type includes both voltage and current. Compared with the previous version- I-7017, the I-7017Z has been much more user-oriented. The 10 differential channels of I-7017Z can be transformed into 20 single-ended channels by the software regarding to your need. What's more, each channel can be configured to accept different kind of input range; how flexible it is! In addition, there is no external resistor needed for measuring the current; all you have to do is to open the shell first and finish the setting by jumper. Measuring the current is as simple as you think! As an ultimate version, the sampling rate of I-7017Z is changeable. There are fast mode and normal mode for your consideration. Please see the table. The I-7017Z also passes 240V over voltage protection, 3000V DC intra-module isolation and 4KV ESD protection.