8000E-MTCP firmware updated to version 1.5.0
Modbus Utility updated to version 1.5.0

Go to download area

Support
       1. Low speed counter (100Hz) of 87K DI module.
       2. 16 Channel reading of 8017HS single-end mode

New function (Auto configuring)

       When replacing a module with another one (with same module ID number), the configuration will be
       keep the same as the data stored on the CPU module.

       If the I/O modules are different to the configuration on the CPU, the L2 and L3 will flash. You have to
       run the Modbus Utility to refresh the configuration on the CPU.

       This is helpful when replacing a damaged module, the worker doesn't need a PC to run Modbus
       Utility to configure the new module again.